ERYONE ER-20 HAUPTPLATINE bulk 20 and too tight to cause

and too tight to cause the filament to be damaged by the gear

my PLA filament snaps by accident during printing

buse Eryone 0

eine zu niedrige Düsentemperatur und der häufige Austausch gegen andere Filamente führen zu diesem Problem

ERYONE ER-20 HAUPTPLATINE bulk 20 and too tight to causeHighlights: 1. ERY32MINI motherboard uses the STM32F103 as the main board 2. ERY32MINI motherboard with built in TMC2209 silent stepper driver 3. ERY32MINI motherboard design is very compact but powerful 4. ERY32MINI motherboard can suitable for ER 20 3d printer spec: 1) Using the 32bit 72MHZ ARM Cortex M3 MCU STM32F103 2) Equipped with Marlin2. 0, a highly modular open source firmware 3) Built in TMC2209 silent stepper driver with UART mode 4) 24V